S700 Barcode Scanner Installation

SHOPLINE POS system operates with Socket Mobile 7ci and S700 Bluetooth barcode scanner. Installation procedures are as below:

1. Appearance overview

Button 1: Scan (Trigger) button

Button 2: Power button

2. Basic operation

1. Power on

Press and hold Button 2 (Power button) until 2 beeps (low-high) and the LED turns blue.

2. Power off

Press and hold Button 2 (Power button) until 2 beeps (high-low) and the LED goes off.

3. Scan barcodes

Hold the scanner about 10 cm from the barcode and press and hold Button 1 (Scan button) until the scanner beeps once.

＊If you hear two beeps (same tone), please check if the tablet device has connected to "Socket S7000" or "Socket 7ci" in the Bluetooth setting.

The solution to connection problems

If the scanning process is not smooth, please do the following:

1. Go to [Settings] and turn on Bluetooth (iOS) or [Settings] > [Network & Accessories] and turn on Bluetooth (Android).

2. Look for the paired "Socket xxx" and click the "i" icon or gear icon on the right.

3. Enter the next page and tap "forget this device". Then power off the scanner.

4. Switch off and on the Bluetooth function of the tablet device and restart the scanner. Pair up the scanner with the tablet and check if it goes back to normal. If the problem still exists, restart the scanner again.

3. Reset the scanner

Ａ. Unpairing

Press and hold Button 2 to power on the scanner.
Press and hold Button 1, then press and hold Button 2 at the same time until you hear 3 beeps (escalating tone). Then release both buttons.
Press and hold Button 2 to restart the scanner until you hear 2 beeps (low-high). Then start the reconnection.

Ｂ. Reconnection

Press Button 1 until a red light flashes. Then scan Barcode 1. If a connection is made, you will hear 3 beeps (escalating).

Barcode 1:
Press Button 1 until a red light flashes, then scan Barcode 2. Please be noted that when you scan Barcode 2, the red light will go off and no sound will be emitted. Please scan the barcode 3 times.
*This step is to scan the scanner to automatically fill in zeros when scanning barcodes, which conforms to the product barcode produced by the system.

Barcode 2:
Press Button 1 until a red light flashes, then scan Barcode 3. Three beeps (flat tone) will be emitted to indicate successful scanning.
*This step is to scan the scanner to automatically fill in zeros when scanning barcodes, which conforms to the product barcode produced by the system.

Barcode 3: